Reasons to install Sonic Cleaning in your Application
There are many reasons to use Sonic Cleaning in your Application. Some of them are listed here below.
Boiler Applications
- Continuously clean heat transferring surfaces, which means better heat transfer and thus higher steam or hot water production.
-
Possibility to use less fuel, to produce the same output effect or hot water.
-
No mechanical wear on the boiler tube surfaces, which means a longer lifetime of about 30% for the boiler tubes.
-
Traditional steam soot blowers or steel ball cleaning is damaging the boiler tubes a lot.
-
The sound reaches into every corner, and can thus penetrate tube packages that have been impossible to keep clean with steam soot blowers.
-
Easy to retrofit into any application.
-
Cost effective and short payback time.
Catalyst Cell Applications
- No mechanical wear on the catalyst cell surfaces, which means a longer lifetime of the catalyst cells.
-
Traditional steam/air soot blowers are damaging the catalyst cells a lot.
-
The sound reaches into every corner, and can thus penetrate catalyst cells that have been impossible to keep clean with steam/air soot blowers.
Electro Filter Applications
- Uniform cleaning .
-
No mechanical wear or damage on the electrodes.
-
Easy to retrofit to improve the filter performance.
Textile Filter Applications
- Uniform cleaning of the entire textile bags, which mean improved performance.
-
No wear on the textile bags, which means longer lifetime.
Cleaning for I.D Fan Applications
- Prevent build-up on fan-blades, which means avoiding shutdown, manual cleaning and additional wear.
Cyclone Applications
- Continuous clean surfaces.
-
No mechanical wear on the structure.
-
Avoiding plugging at the outlet.
Marine Applications
- No mechanical wear on Boiler tubes or Catalyst cells.
-
Reduced need for water washing.
-
No accumulation of soot deposits, which means no stack fires and no soot flakes on deck.
Spray drier Applications
- Continuous clean surfaces, which means improved product quality.
-
No mechanical wear on the structure.
-
Avoiding plugging at the outlet.
-
Longer operation time possible between washing.
-
Minimized waste products left in the Drier at the end of a production cycle.
Silo Applications
- To prevent build-ups on the inner walls and roof of a Silo.
Note:
To avoid Bridging of the bulk material, or to get
a Quicker discharge than with other methods,
then use our Pulsator System.